KPYRO-TUCKER UNLOOPER

This is a "newbie" guide to building a great Unlooper!

This Unlooper WORKS with the HU !

Hook up to computer, reboot in DOS mode, run the ATMEL.EXE or HUATMEL.EXE
(this unit in-circuit flashs great!) and flash the atmel chip.

On DIP switch, all off, #3 on.   Jumper pins 13 & 14 together and it
programs the HU in 2 seconds!

I chose this design for a few reasons.. The main reason is that it is a one-side PCB which makes it easier for a newbie to build (don't have to worry about aligning both sides, which proves to be very difficult to do!)

Also, it has a switch so that you do not need to keep taking out the card and reinserting it a million times while trying to get an ATR in a Black Sunday card!

The final reason is that it has a dip switch, which gives you more control over glitching frequencies.

 
This is the second one I have built, the first being used as I type this to watch "Coyote Ugly" on PPV in an EMU setup with a Black Sunday card! Works fantastic and no video glitches! (works with the WTXBS01.EXE only for EMU, it does in-circuit flash and will unloop a BS card with SU2v2 w/SU@ code on the chip)
 
Click on a link below to get started!
Step 1:
The Supplies!
Step 6:
Make Resistors
Step 2:
Making the PCB
Step 7:
Adding DIPs
Step 3:
Drilling Holes
Step 8:
Adding Capacitors
Step 4:
Trimming the PCB
Step 9:
Adding Components
Step 4:
Adding Jumpers
Step 10:
Final Components
Step 11: Its FINISHED!
If you have any questions, you can find me on IRC: "irc.intmain.com" Nick: Dennis
Or Post your Questions and Comments in the Forum.
 Enjoy! and have fun building!
Get the Kpyro-Tucker Unlooper Plans here!